Our Services
Golf Club Fitting, Building and Repair in Dallas
Building new sets is most of what we do. We look after the irons you already own too, and we will tell you honestly which one you need.
Service 01
Iron fitting
A session on your swing, ball flight and strike, so the rest of the build has something real to aim at.
We watch you hit balls and look at what the numbers say: swing speed, attack angle, strike pattern and ball flight. Then we talk about how you want the club to feel at impact, because two golfers with the same numbers often want very different clubs. You leave with a written specification whether or not you have us build the set.
- Session lengthAbout 90 minutes
- What you getFull written specification
- FeeCredited against a build
Service 02
Custom iron builds
Complete sets built from head to grip around your fitting numbers.
Heads, shafts, ferrules and grips are assembled by hand, one club at a time. Lofts and lies are bent to your numbers, shafts are cut to your length, swing weight is balanced across the set so the 8 iron feels like the 5, and grips go on at the size that suits your hands.
- Typical set4 iron to pitching wedge
- Build timeTwo to three weeks
- Final checkEvery club measured again
Service 03
Loft and lie
Forged irons move with use. We measure every club and bend it back to spec.
Strike the turf a few thousand times and a forged head will drift, usually a degree or two and rarely by the same amount across the set. That shows up as one club that goes left and another that comes up short. We measure the whole set, bend each head back, and give you the before and after numbers.
- TurnaroundSame day in most cases
- CoversFull set or single clubs
- SuitsForged heads, most cast heads
Service 04
Reshafting
New shafts cut, installed and trimmed to the length and flex you play best.
Whether you have broken a shaft or want to move to something lighter, heavier, softer or stiffer, we pull the old shaft, clean the hosel properly, and install the new one to your length with the correct tip and butt trimming. Swing weight is rechecked afterwards so the club still feels like the rest of the set.
- OptionsSteel and graphite
- IncludesNew ferrule and grip fitting
- TurnaroundThree to five days
Service 05
Regripping
Grips in the size, material and build-up that suit your hands.
Grips are the only part of the club you touch, and they wear out faster than anything else. We will talk through rubber, cord and hybrid, standard through jumbo, and extra wraps under the top hand if you need a little more build-up. Old tape comes off properly, not just the grip.
- TurnaroundWhile you wait, in most cases
- SizesUndersize to jumbo
- AdviceBring your gloves
Service 06
Repairs
Loose heads, rattles, worn ferrules and the rest. Bring it in and we will take a look.
A rattle is usually a loose tip weight or a broken shaft tip, and a head that turns is an epoxy failure, not the end of the club. We will diagnose it honestly, tell you what it costs, and tell you when a club is not worth repairing rather than charging you to find that out.
- AssessmentNo charge
- Common jobsReheading, ferrules, rattles
- TurnaroundDepends on the job
To achieve greatness, use the best irons that fit you.
Tell us about your game and what you want your irons to do. Whether you play off 18 or play for a living, we'll find a time for a fitting.